Powering fans up to 24W

With a maximum output power of 24W, the NV-PS1 has the capacity to run several power-hungry high-speed fans using optional NA-YC1 y-cables or fan hubs such as the NA-FH1 or NV-FH2. At the same time, it runs highly efficient even if only a single, low power fan is connected..

High efficiency, minimum standby power

The NV-PS1 is not only extremely efficient running higher loads, it also only requires 0.075W in standby when no load is applied, making it an excellent choice for applications where maximum energy efficiency is required and where fans may be switched off intermittently.

Wide range AC input, EU/US/UK plugs included

The NV-PS1 supports an input range of 90~264V AC (47-63Hz), making it fully compatible with both 115V and 230V grids. Including modular connectors for type C (CEE 7/16, for Europe, Russia, Brazil, South Africa, etc.), type A (NEMA 1-15, for USA, Canada, Mexico, Japan, etc.) and type G (BS 1363, for UK, Ireland, Singapore, etc.), the NV-PS1 is fit to run in a broad variety of environments.

4-pin Molex adaptor for fan connectors

The NV-PS1 features a native 5.5mm (outer diameter) / 2.1mm (inner diameter) barrel type connector and includes an NA-AC10 adaptor to 4-pin Molex that allows for connecting all Noctua 12V fans (both 3-pin and 4-pin) as well as many third party 12V fans, y-cables or fan hubs with 4-pin input connectors.

Alternative applications

While the NV-PS1 is primarily targeted towards powering fans, its native 5.5mm OD / 2.1mm ID barrel type connector also makes it suitable for a wide range of other applications such as powering single board computers (SBC) that can use 12V, like Arduino or other devices.

Fan speed control with optional NA-FC1 controller

The NV-PS1 is protected against overvoltage, overcurrent and short-circuits and carries safety certification from both UL and TÜV. Unlike many cheap power supplies, it is fully CE/UKCA compliant (EMC 2014/30/EU & LVD 2014/35/EU) and meets all applicable standards for EMC (EN 55032 Class B and FCC (Part 15 Subpart B) Class B) and safety (EN 60950-1:2006, EN 62368-1, IEC 62368-1:2014, UL 60950-1, etc.).

Protection and safety

In addition to the 135cm cable of the NV-PS1 power supply, the 30cm long NA-AC10 adaptor for fan connection and the fan’s 20cm primary cable, the NV-FS1 set includes an NV-EC4 1m extension cable that increases the total reach to 2.85m. The NA-FC1 controller can be placed before or after the extension cable for maximum flexibility.

6-year warranty

The NV-PS1 features an MTTF rating of 50,000 hours under full load at 25°C ambient temperature (MIL-HDBK-217F standard) and comes with Noctua’s standard 6-year manufacturer’s warranty, making it a dependable long-term choice for applications that require a quality power supply that will run safely for many years.