Key Features

• Compact and powerful DDC pump

• Estimated lifespan of more than 50,000 hours at 12V

• Electronically commutated ball motor pump

• Ultra-hard, wear-resistant ceramic bearing ball

• Wet-running design lubricated directly by the coolant

• Maintenance-free operation

• Consistently quiet operation throughout its lifespan

• Pump performance can be regulated over a wide range

• All parts in contact with the coolant are completely corrosion-free

• Pump tacho output

◆ Pump Design and Durability

A conventional shaft with bearings and seals is not used or needed.

The spherical bearing of the rotor unit on the ceramic bearing ball has many advantages. The development of bearing clearance is technically impossible, which prevents an increase in noise level over the lifespan of the pump.

The bearing is self-adjusting, making the pump consistently quiet in operation over its full lifespan. The pump is directly lubricated by the coolant (wet-running pump). Therefore, no maintenance is required.

As the rotor is magnetically held in place, even small dirt particles pose no problem for the mechanism, and blocking of the pump is not possible under normal operating conditions. Even after a long period of standstill, reliable operation is ensured.

The permanent magnetic rotor unit is frictionlessly driven by a magnetic field produced by the surrounding stator.

◆ Compact Design

The stator is completely built around the rotor, therefore the pump, at only 38mm high, is only slightly higher than the stator unit.

It therefore fits in almost any PC case, whether Super Tower or Barebone. Separate magnetic shielding is usually not required.

The ball motor principle allows powerful yet power-saving operation. The pump can be regulated by variations in the DC operating voltage over a wide range.

◆ Pump Tacho

With a 4-pin Molex connector as pump tacho output for mainboards or control units.

Important: The Laing pump's electronics are not waterproof.

Please make sure that the electronic components do not come into contact with water during installation or when working on the pump.

When replacing the top, always ensure a proper fit of the O-ring seal and avoid spills when filling the Laing reservoir.

Damage caused by water coming into contact with the electronic components is not covered by warranty.